2013 Toyota Tundra

2013 Toyota Tundra recalls (6)

• WHEELS:LUGS/NUTS/BOLTS/STUDS

  Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2013-2017 Toyota Tundra and Sequoia vehicles accessorized with Southeast Toyota accessory 20-inch Rockstar wheels installed by Southeast Toyota or a Southeast Toyota dealer. The Rockstar wheels were installed with lugnuts that may crack and detach.

  Remedy: SET will notify owners, and dealers will install new replacement lugnuts, free of charge. The recall began June 23, 2017. Owners may contact SET customer service at 1-866-405-4226. SET's number for this recall is SET17A.

• WHEELS:LUGS/NUTS/BOLTS/STUDS

  Gulf States Toyota, Inc. (GST) is recalling certain model year 2013-2014 Toyota Tundra vehicles modified by GST as part of certain vehicle packages to be equipped with a combination of non-Toyota-brand 20-inch alloy wheels and chrome plated lug nuts. The coating on the lug nuts may give, causing the lug nuts to loosen or the wheel studs to fracture.

  Remedy: GST will notify owners, and dealers will replace 20 lug nuts and torque them to specification, free of charge. The recall began in August 2014. Owners may contact GST customer service at 1-800-444-1074.

• AIR BAGS:FRONTAL:SENSOR/CONTROL MODULE-INACTIVE

  Southeast Toyota Distributors, LLC (SET) is recalling certain models interspersed through model years 2009 through 2013 as follows: model year 2009-2012 Tacoma, 4Runner, Camry, Camry Hybrid, Prius, and RAV4; model year 2009-2010 Avalon, FJ Cruiser, and Highlander Hybrid; model year 2010-2013 model year Corolla, Sienna and Tundra; model year 2009-2013 Highlander and Venza; model year 2012 Prius V; and model year 2010-2012 Sequoia. During modification by SET to include accessories such as leather seat covers, seat heaters or headrest DVD systems, these vehicles may not have had the passenger seat occupant sensing system calibration tested. Without passing the calibration test, the occupant sensing system may not operate as designed.

  Remedy: Southeast Toyota will notify owners, and dealers will test the sensitivity of the occupant detection sensors, and recalibrate them as necessary. The recall began on March 21, 2013. Owners may contact Southeast Toyota at 1-800-301-6859.

• EQUIPMENT:OTHER:LABELS

  Southeast Toyota is recalling certain model year 2008 and 2010-2013 Toyota Tundra, 2010-2012 Rav4, 2012 Toyota Sequoia, 2010-2011 Toyota Corolla, 2010-2011 Toyota Camry and Camry Hybrid, 2010-2013 Toyota Highlander and Highlander Hybrid, 2010-2013 Toyota FJ Cruiser, 2011 Toyota Land Cruiser, 2010-2013 Toyota Venza, 2010-2011 Toyota 4Runner, 2010-2013 Toyota Tacoma, 2011-2012 Toyota Sienna, 2012 Toyota Prius, 2013 Scion FR-S, 2011 Scion XD, 2011 Scion XB, and 2012 Scion TC vehicles. These vehicles were sold with labels that were outside the allowable one percent of accuracy of actual weight added. Thus, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) Number 110, "Tire Selection and Rims."

  Remedy: Southeast Toyota will notify owners and provide a corrected label with instructions concerning its installation. A small group of the affected vehicles will need additonal remedies which are still being developed. The recall began on May 28, 2013. Owners may contact Southeast Toyota at 1-800-301-6859.

• STEERING:HYDRAULIC POWER ASSIST SYSTEM

  Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2008-2022 Sequoia and 2007-2021 Tundra vehicles. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak.

  Remedy: Dealers will inspect and replace the power steering gear assembly as necessary, free of charge. Owner notification letters were mailed on January 21, 2022. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's numbers for this recall are 21TB10 and 21TA10.

• STEERING:HYDRAULIC POWER ASSIST SYSTEM

  Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain JTEKT power steering gear assembly service parts for 2007-2021 Tundra and 2008-2022 Sequoia, part numbers 44250-0C160, 44250-0C131, 44250-0C170, and 11250-0C121. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak.

  Remedy: Dealers will inspect and replace the power steering gear assembly, free of charge. Owner notification letters were mailed on February 17, 2022. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's number for this recall is 21TH01.

2013 Toyota Tundra safety ratings

Source: NHTSA NCAP ratings.

2013 Toyota Tundra owner complaints (15)

• ELECTRICAL SYSTEM

  The contact owns a 2013 Toyota Tundra. The contact stated that the horn failed to operate as needed. The vehicle was taken to an unknown dealer where the contact was informed that there were no recalls on the VIN related to the failure. The contact was provided an estimate for the repair. The manufacturer was notified of the failure, and the contact was provided the same information as provided by the dealer. The vehicle was not repaired. The failure mileage was approximately 130,000.

• WHEELS

  My factory stock Toyota painted steel wheels rotted and I had a 6 inch long area rusted through inside the rim losing air. I was advised by my tire center ,that i took it to ,that was not safe to drive on. I called my local Toyota dealer service manager and was told it was road corrosion and was not under any warranty. What would of happened if I had been on the highway and had a rapid deflation of the tire or what if the wheel broke and came apart. The truck has no rust. I replaced all 4 wheels the very next day. These wheels should be recalled and inspected and replaced if needed before someone gets hurt.

• ELECTRICAL SYSTEM

  Odometer Fraud. The contact purchased a 2013 Toyota Tundra. The contact stated that while the vehicle was taken to a local dealer for repairs, it was discovered that there was a mileage discrepancy. The vehicle was an independent dealer sale. At the time of purchase, the vehicle mileage was 84,00 and upon inspection at a local dealer, it was discovered that the mileage was 175,000.

• UNKNOWN OR OTHER

  Secondary Air injection pumps went bad

• VEHICLE SPEED CONTROL

  While driving at various speeds (25mph or 65mph) I let off on the accelerator to either slow down or come to a stop, when accelerating again I get a check engine light and I have no power. I limp along for several minutes then all of a sudden the fuel pedal sensor that tells the ecu where the fuel pedal is at catches up and I’m able to continue on with my ride. This is a very dangerous situation to have happen because you are not expecting it and when it does happen it is very unnerving. I’ve spoken to various Toyota dealers and there seems to be a nonchalant attitude about it.

• ENGINE

  Mechanic stated that the secondary air injection system is a common problem in this generation of Tundra.. I have had my check engine light come on 3 different times and addressed each by replacing all the sensors to the secondary air injection system. My mechanic is a Toyota dealer mechanic. My issue is that my car has lost power to accelerate at highway speeds and came close to causing and accident. I am now at my third attempt at replacing now the actual pump. I understand that Toyota has replaced the gooseneck part where the hose is attaches to the pump. This tells me that there was a problem or else why would they change a good thing? Is there a warranty for this part?

• ENGINE AND ENGINE COOLING

  The contact owns a 2013 Toyota Tundra. The contact stated that upon taking the vehicle in for inspection, the vehicle failed the inspection. The contact was informed that a failure with the air injection pump had been detected. The check engine warning light was illuminated. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 64,000.

• ELECTRICAL SYSTEM,VISIBILITY/WIPER

  Backup camera cuts in and out. When put in reverse only shows a blue screen. checked connections and seems to happen mostly when it rains.

• STEERING

  Steering has gone out twice in 2 months. Rack and pinion had to be replaced.

• FUEL/PROPULSION SYSTEM

  It would crank but not start

• ENGINE

  Cam tower leaks oil on the heat shield below it. Cam tower uses rtv rubber seal instead of a gasket. The rubber deteriorates and the cam tower leaks engine oil on the heat shield. Not clear why Toyota used form in place rubber material instead of real gasket. Repair however is major. Need to take apart engine to repair. Major repair. The fix is to replace it with the same material again. Which is subject to deteriorate again. This is a know issue on the 5.7 L engine. Toyota seems to have its head in the sand hoping they shouldn’t be forced to recall. However this is a know design flaw resulting in leaking oil on the heat shield. With no Toyota recommended new design or parts repair except to do it all over again and hope it doesn’t leak again it’s ridiculous. . Terrible design that leaks oil on the heat shield.

• SEAT BELTS

  Plastic piece and spring have ejected from the seat belt receiver and now the receiver does not latch on to the seat belt when it is inserted into the receiver (driver side but could happen to any/all). The seat belt no longer buckles.

• ENGINE

  The contact owns a 2013 Toyota Tundra. The contact stated while driving approximately 70 MPH, the vehicle and steering wheel started shaking. The contact pulled over safely and inspected the vehicle and noticed there was power steering fluid leaking from the vehicle. The vehicle was taken to an independent mechanic who diagnosed the failure as an engine leak. There was initially no warning light illuminated; however, after arriving home, the check engine warning light illuminated. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 122,000.

• WHEELS

  In 2017 while driving home from a restaurant with my husband, mother and sister when on highway 60 in Show Low Arizona we started experiencing a shaking which seemed to come from the from end of the truck. Since we were only a short distance from home we slowly made our way down the side road. As soon as we turned into our driveway the truck came to a quick stop. We jumped out and found that the passenger front tire and rim had separated from the truck. A full bed tow truck came and took the truck to Hatch Toyota in Show Low Arizona. The second incident occurred last year (2021) while we were moving to Sarcoxie Missouri. My husband was on Interstate 40 just east of Albuquerque when he experienced the truck shaking and upon immediately pulling off to the side of the road noted the left front wheel and rim had separated from the vehicle. The truck was taken to the Albuquerque Toyota for repair. I am having the rims replaced at this time as I understand that after-market rims may be the cause. I would really like to know for sure. I would not want to trade this truck in for fear of another family being harmed.

• ELECTRICAL SYSTEM

  We are a surveying company with a fleet of 35 Toyota Tundra trucks. Two of the trucks in our Denver location have had the engine wiring harness chewed and destroyed by rodents in the parking lot. Each is costing $6,500 to repair. The second truck shorted out and the check engine lights came on, would not start. I am glad this did not fail while someone was driving it. Toyota uses a flexible pipe wrap over some of this wiring that is soy based; the plastic wrapped wiring is unaffected. This problem is well documented on the internet, and very common. Toyota is profiting in a big way from this design defect, and they are compromising safety by risking engine failures due to shorts. They should be forced to install hard plastic wire covers over these harness wires to prevent this damage.